Abstract
SUMMARY An adaptive control system is proposed in which a given amount of tool wear is allowed per operation. The objective of the control system is to machine a certain feed distance in the minimum tune using no more than the wear allowed and working within the conventional adaptive control constraints. The average rate at which the operation progresses can thus be regulated by appropriately setting the wear target. The adaptive control system has been applied to the control of a lathe performing a simple bar turning operation. An on-line computer receives transducer responses, calculates and issues feed and speed corrections. The optimization policy requires the tool wear rate to be estimated while cutting and in this work the estimation was made from the cutting process variables including the tool-work thermocouple voltage. Workpiece disturbances in the form of hardness changes were introduced and the experimental responses of the control system to these disturbances are presented. The success of esti...
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
