Abstract
A single-stage, bidirectional, current-source converter (CSC) topology to interface a dc microgrid with an ac grid is reported in the literature. In this topology, under a balanced grid voltage condition, the dc-link inductor current can be regulated over a wide range—from zero to rated value—while the ac-side current has low harmonic distortion. However, unbalanced grid voltages result in second-harmonic pulsation in the current and power on the dc side of the converter. In addition, the ac-side currents will be unbalanced due to the presence of a negative-sequence component. This would result in undesired tripping of the converter if one of the phase currents exceeded its rated value. Various control loop structures for the operation of voltage-source converter under unbalanced grid voltage conditions are reported in the literature. However, use of similar control loop structures for CSC may lead to unstable operation. Therefore, a control scheme to inject balanced three-phase currents into the ac grid under an unbalanced grid voltage condition is proposed in this paper. The stability of the proposed control scheme is studied using a small-signal model of the converter. Performance of the proposed control scheme is studied using MATLAB/Simulink and is experimentally validated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.