Control of oscillating combustion and noise based on local flame structure

Abstract

To control combustion oscillations, the characteristics of an oscillating swirl injection premixed flame have been investigated, and control of oscillating combustion and noise based on local flame structure has been conducted. The r.m.s. value of pressure fluctuations and noise level show significantly large values between ϕ = 0.8 and 1.1. The beating of pressure fluctuations is observed for the large oscillating flame conditions in this combustor. Relationship between beating of pressure fluctuations and local flame structure was observed by the simultaneous measurement of CH/OH planar laser induced fluorescence and pressure fluctuations. The local flame structure and beating of pressure fluctuations are related and the most complicated flame is formed in the middle pressure fluctuating region of beating. The beating of pressure fluctuations, which plays important roles in noise generation and nitric oxide emission in this combustor, could be controlled by injecting secondary fuel into the recirculating region of oscillating flames. Injecting secondary fuel prevented lean blowout, and low NO x combustion was also achieved even for the case of pure methane injection as a secondary fuel. By injecting secondary fuel into the recirculating region near the swirl injector, the flame lifted from the swirl injector and its reaction region became uniform and widespread, hence resulting in low nitric oxide emission. Secondary mixture injection, fuel diluted with air, is not effective for control of combustion oscillations suppression and lean blowout prevention.