Abstract
The possibilities of thermal imaging and spectral technology in organization of the control of laser technological processes of high-temperature modification of structural materials are analyzed. It is shown that the application of thermal imaging technology is reasonable when adjusting these processes. For continuous control it is more perspective to apply small spectral technique. Solutions are proposed that allow continuous monitoring on the basis of determination of two parameters: the effective heating temperature Te of the treated surface in the area of influence of laser radiation and parameter a associated with the effective heating area. It is shown that introduction of small-sized spectral devices for continuous monitoring into the feedback loop of the control system for laser set-ups is promising.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.