Abstract

Previous studies of control of fingertip forces in skilled manipulation have focused on tasks involving two digits, typically the thumb and index finger. Here we examine control of fingertip actions in a multidigit task in which subjects lifted an object using unimanual and bimanual grasps engaging the tips of the thumb and two fingers. The grasps resembled those used when lifting a cylindrical object from above; the two fingers were some 4.25 cm apart and the thumb was approximately 5.54 cm from either finger. The three-dimensional forces and torques applied by each digit and the digit contact positions were measured along with the position and orientation of the object. The vertical forces applied tangential to the grasp surfaces to lift the object were synchronized across the digits, and the contribution by each digit to the total vertical force reflected intrinsic object properties (geometric relationship between the object's center of mass and the grasped surfaces). Subjects often applied small torques tangential to the grasped surfaces even though the object could have been lifted without such torques. The normal forces generated by each digit increased in parallel with the local tangential load (force and torque), providing an adequate safety margin against slips at each digit. In the present task, the orientations of the force vectors applied by the separate digits were not fully constrained and therefore the motor controller had to choose from a number of possible solutions. Our findings suggest that subjects attempt to minimize (or at least reduce) fingertip forces while at the same time ensure that grasp stability is preserved. Subjects also avoid horizontal tangential forces, even at a small cost in total force. Moreover, there were subtle actions exerted by the digits that included changes in the distribution of vertical forces across digits and slight object tilt. It is not clear to what extent the brain explicitly controlled these actions, but they could serve, for instance, to keep tangential torques small and to compensate for variations in digit contact positions. In conclusion, we have shown that when lifting an object with a three-digit grip, the coordination of fingertip forces, in many respects, matches what has been documented previously for two-digit grasping. At the same time, our study reveals novel aspects of force control that emerge only in multidigit manipulative tasks.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.