Abstract
In this paper, the design of a distribution static compensator (DSTATCOM) based on cascaded transformer multilevel inverter is proposed. The topology requires controlling only a common dc storage capacitor. Two-level ramp-comparison current control method is extended for the multilevel inverter using phase-shifted multi-carrier PWM. The method provides equal switching stress and power handling for all the cascaded units. The net switching frequency increases while the ripple magnitude reduces using multilevel topology. These cause the feedforward gain to increase leading to a higher bandwidth of the control loop. An expression of the feedforward gain is derived for fixed switching frequency modulation of the inverter. It is shown that the use of proportional plus resonant controller with proposed multilevel modulation improves the tracking characteristics at fundamental frequency. A seven-level inverter based DSTATCOM is proposed for the application to the three-phase medium voltage distribution system and the results are shown through the PSCAD/EMTDC simulation. The proposed modulation and control scheme is validated through the experimental results that are obtained using the laboratory model of a single-phase, five-level inverter based DSTATCOM.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.