Control and stability analysis of DC microgrid system including wind and solar generation sources and grid‐connected voltage source converter

Abstract

SummaryThe study system in this paper is a grid‐connected DC microgrid system comprising PV and wind generation sources, resistive and constant power loads (CPLs), and grid‐connected VSC. The VSC keeps the DC link voltage constant, and the wind and PV sources operate in maximum power point tracking (MPPT) mode, and thus, the DC–DC converters related to these sources act such as controlled current sources behaving similar to negative CPLs. The study system suffers from the stability under high CPL penetration and weak AC grid conditions. Hence, this paper investigates and enhances the system stability under both high CPL penetration and weak AC grid conditions. To do this, modal and small‐signal stability analysis of the system is carried out, and then, as the main findings, impacts of the wind and PV sources output powers, CPL power, and AC grid short‐circuit power on the system stability are studied. Next, as the main contribution, VSC control structure is modified by adding stabilizing signals to enhance the system stability under high CPL penetration, reduced output powers of the wind and PV sources, and weak AC grid conditions. At the end, several simulation results verify the theoretical results at different conditions.