Abstract
Photo-catalytic performance for oxide films, here for inkjet-printed TiO2 (ca. 1 μm thickness on FTO) and for spray-pyrolysis-coated Nb2O5 (ca. 1 μm thickness on FTO), is affected by oxygen vacancies that form during vacuum-heat treatment at 550 °C. The effects of the oxygen vacancies are associated with formation of Ti(III) and Nb(IV) sites, respectively, and therefore optically visible as “grey” coloration. Photo-electrochemical light-on-off transient experiments are performed in the limit of thin film photoanodes, where front and back illumination result in the same photo-current responses (i.e. with negligible effects from internal light absorption gradients). It is shown that generally the magnitude of photo-currents correlates linearly with light intensity, which is indicative of dominant “photo-capacitive” behaviour. At an applied voltage of 0.4 V vs. SCE (in the plateau region of the photo-current responses) the potential and also the pH (going from 1.0 M KOH to 0.1 M HClO4 in the presence of methanol quencher) have no significant effect on photo-currents; that is, surface chemical/kinetic effects appear to be unimportant and interfacial hole transfer may be rate limiting. Under these conditions (and based on a simplistic mechanistic model) changes in photo-currents introduced by oxygen vacancy doping (detrimental for TiO2 and beneficial for Nb2O5) are assigned primarily to changes in electron mobility.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
