Abstract
ABSTRACTContinuous dosing of a fast initiator during the suspension polymerization of vinyl chloride has been carried out in a pilot‐scale reactor. The kinetics course of this polymerization and the particle features of the resulting grains were discussed and compared to the conventional polymerization with the same conversion and maximum reaction rate. It was found for the system used that a suitable dosage trajectory allows the reaction rate to remain constant during polymerization. This decreases the polymerization time up to 53% compared with the conventional suspension polymerization, while the molecular weight distribution and molecular weight of the final grains remained almost unchanged. SEM micrographs revealed that PVC grains prepared using this polymerization process had irregularly shaped, uneven particle surfaces and larger particle sizes. The grains also featured high porosity with loosely aggregated smaller primary particles that led to low levels of residual unreacted monomer. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2016, 133, 44079.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
