Continental growth at convergent margins facing large ocean basins: a case study from Mesozoic convergent-margin basins of Baja California, Mexico

Abstract

Mesozoic rocks of the Baja California Peninsula form one of the most areally extensive, best-exposed, longest-lived (160 my), least-tectonized and least-metamorphosed convergent-margin basin complexes in the world. This convergent margin shows an evolutionary trend that may be typical of arc systems facing large ocean basins: a progression from highly extensional (phase 1) through mildly extensional (phase 2) to compressional (phase 3) strain regimes. This trend is largely due to the progressively decreasing age of lithosphere that is subducted, which causes a gradual decrease in slab dip angle (and concomitant increase in coupling between lower and upper plates), as well as progressive inboard migration of the arc axis. This paper emphasizes the usefulness of sedimentary and volcanic basin analysis for reconstructing the tectonic evolution of a convergent continental margin. Phase 1 consists of Late Triassic to Late Jurassic oceanic intra-arc to backarc basins that were isolated from continental sediment sources. New, progressively widening basins were created by arc rifting and sea floor spreading, and these were largely filled with progradational backarc arc-apron deposits that record the growth of adjacent volcanoes up to and above sea level. Inboard migration of the backarc spreading center ultimately results in renewed arc rifting, producing an influx of silicic pyroclastics to the backarc basin. Rifting succeeds in conversion of the active backarc basin into a remnant backarc basin, which is blanketed by epiclastic sands. Phase 1 oceanic arc–backarc terranes were amalgamated by Late Jurassic sinistral strike slip faults. They form the forearc substrate for phase 2, indicating inboard migration of the arc axis due to decrease in slab dip. Phase 2 consists of Early Cretaceous extensional fringing arc basins adjacent to a continent. Phase 2 forearc basins consist of grabens that stepped downward toward the trench, filled with coarse-grained slope apron deposits. Phase 2 intra-arc basins show a cycle of (1) arc extension, characterized by intermediate to silicic explosive and effusive volcanism, culminating in caldera-forming silicic ignimbrite eruptions, followed by (2) arc rifting, characterized by widespread dike swarms and extensive mafic lavas and hyaloclastites. This extensional-rifting cycle was followed by mid-Cretaceous backarc basin closure and thrusting of the fringing arc beneath the edge of the continent, caused by a decrease in slab dip as well as a possible increase in convergence rate. Phase 2 fringing arc terranes form the substrate for phase 3, which consists of a Late Cretaceous high-standing, compressional continental arc that migrated inboard with time. Strongly coupled subduction resulted in accretion of blueschist metamorphic rocks, with development of a broad residual forearc basin behind the growing accretionary wedge, and development of extensional forearc (trench–slope) basins atop the gravitationally collapsing accretionary wedge. Inboard of this, ongoing phase 3 strongly coupled subduction, together with oblique convergence, resulted in development of forearc strike-slip basins upon arc basement. The modern Earth is strongly biased toward long-lived arc–trench systems, which are compressional; therefore, evolutionary models for convergent margins must be constructed from well-preserved ancient examples like Baja California. This convergent margin is typical of many others, where the early to middle stages of convergence (phases 1 and 2) create nonsubductable arc–ophiolite terranes (and their basin fills) in the upper plate. These become accreted to the continental margin in the late stage of convergence (phase 3), resulting in significant continental growth.