Abstract
Surface Strength of the gear tooth depends on the contact stress and the bending stress caused due to the applied load on the tip of its gear tooth. Analysis has become popular in decreasing the failures. Fatigue causes in the root bending stress and Surface indentation causes in the contact stress. Then modified Lewis beam strength is used for bending stress and the AGMA method is used for contact stresses by varying the face width. Analytical results are based on Lewis formula and the theoretical values were calculated by AGMA standard so the results were validated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Recent Technology and Engineering (IJRTE)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
