Contact pressure prediction in total knee joint replacements. Part 2: Application to the design of total knee joint replacements.

Abstract

The general elasticity contact theory for elliptical geometry developed in Part 1 (1) has been applied to the design of current total knee joint replacements. A two-step curve-fitting technique using cubic spline interpolation routines has been adopted to represent the full elasticity solutions. The curve fit results of the maximum contact pressure have been compared with the full elasticity solution for a specified elliptical geometry and different polyethylene thicknesses and good agreement has been demonstrated. The computing time required by the curve-fitting technique is very small compared with the full elasticity solution and therefore can readily be applied to the design of knee joint replacements. Furthermore, reasonable agreement has also been found for the contact area for a typical knee joint design between the present theoretical prediction and the experimental measurement using pressure-sensitive film. Predictions of the maximum contact pressure have been made for an existing knee joint replacement in order to illustrate the present analysis in the design cycle. It has been shown that the effect of the thickness of ultra high molecular weight polyethylene is relatively small on contact stress predictions provided a sufficiently large value is chosen. On the other hand, the effect of conformity has a much greater influence on the contact stress distribution, particularly in the direction of the smaller principal radius.