Abstract

This paper presents the design and evaluation of an Atomic Force Microscope (AFM) probe with exchangeable tips. It can be employed to replace tips worn out during imaging, or to exchange tips during multi-step nano-metrology and manipulation tasks. The probe employs a liquid meniscus-based micro-gripper at its end to enable exchange of tips. The design of the gripper and tip-supply station are discussed and the stiffness of the gripper is analyzed. Subsequently, the system is fabricated and evaluated by performing contact mode imaging of a calibration grating. The resulting topographical image is shown to be free of artifacts, thereby underscoring the fact that the micro-gripper can grip the AFM tip adequately well to resist the effect of lateral forces in contact mode AFM. It also shows that probes with exchangeable tips can be used in applications similar to that of a conventional AFM probe.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.