Year-end Sale % OFF 
Abstract
The necessity of the gas flowmeters calibration with the use of gas at expected working pressure is now beyond dispute. Most of gas meters types show the sensitivity to the parameters of the measured gas. The calibration factor, usually expressed as number of pulses per unit of volume, shifts when there is a change of an operating pressure. Change of operating pressure causes shift of calibration curve - so gas meters should be calibrated as close to operating conditions as possible. Polish Gas Transmission System Operator GAZ-SYSTEM SA decided to build the High Pressure Gas Meters Calibration Facility (HPCF) where natural gas is used as a working medium. The paper presents measures taken to overcome technical and metrological problems encountered during design and construction of the facility.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
