Abstract
Mold trials are critical in the mold development process; therefore, it is necessary to develop predictive models that can control processing results and solve problems in processing parameter optimization to ensure manufacturing efficiency and processing quality. Using the six sigma method, this research constructed an optimized 3C (Computer, Communication, and Consumer electronic) product mold manufacturing process predictive model, and conducted an empirical study on the largest electronic products foundry. The Taguchi parameter design method, the back propagation network (BPN) prediction method, and genetic algorithms (GAs) were used to establish an optimization search module. The surface quality was inferred by the network predictive model as a limiting condition for acquiring the maximized material removal rate in milling. The optimized milling processing parameters of the maximum fitness degree can be determined by GA. The findings can serve as a practical reference for quality improvements and decision planning.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.