Abstract
In this paper, the construction solution and the method of programming the platform for spatial imaging with sensors are presented. The mechanical construction of the platform is described in detail, as well as the electrical components needed for movement of the sensor carrier in the horizontal plane. Movement is achieved by two stepper motors, and movement control is obtained by connecting the corresponding Arduino and LabVIEW programs. The movement of the carrier from the initial position, through four arbitrary points, until it is placed again in the initial position was realised. The paper provides relevant technical data about the platform, connection diagrams, parts of the program code and accompanying discussion.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
