Abstract
The process of construction and evaluation of a shunt prototype for AC-DC transfer produced by Inmetro, built with low-cost materials and using commercially available thin film chip resistors will be presented. The main objective of this work is fully achieved, obtaining an equipment with characteristics that allow its use as standard in the calibration of AC current sources of high accuracy, in a wide frequency range.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
