Constructing Si@CN@MXene from silicon waste as high-performance lithium-ion battery anodes

Abstract

Silicon represents one of the most attractive materials for anodes in lithium-ion batteries (LIBs) due to highest theoretical specific capacity. Thus, there is a most urgent need to prepare Si-based nano materials in a very efficient way, and develop some reasonable approaches for their modification in order to resolve the short-falls of Si anode, which include both low conductivity and huge volume changes during intercalation of lithium ions. In this work, the kerf loss silicon (KL Si) from the photovoltaic industry has been used as an inexpensive Si source for the synthesis of the Si@CN@MXene (SCM) composite to be applied as an anode material. Meanwhile, the chitosan works as the charge bridge in sequence with the Si and MXene nanosheets under electrostatic force during composite preparation. The MXene nanosheet and N-doped carbon layer that build up during chitosan calcination can be attributed to forming a hierarchical high-speed conductive network over the surface of silicon, which contributed to alleviate the volume expansion of silicon. The SCM electrode discharge capacity was obtained at a stable value of 900.8 mAh g−1 at 0.5 A g−1, 861.9 mA g−1 at 1 A g−1 and 657.6 mA g−1 even at 2 A g−1 after 100 cycles. The SCM electrode also exhibited good rate performance from 0.2 to 5 A g−1. Therefore, this study recommends that the method is very promising for producing the silicon anode material for LIBs from KL Si.