Abstract

ABSTRACT We present Herschel observations of the far-infrared (FIR) fine-structure (FS) lines [C ii]158 μm, [O i]63 μm, [O iii]52 μm, and [Si ii]35 μm in the z = 2.56 Cloverleaf quasar, and combine them with published data in an analysis of the dense interstellar medium (ISM) in this system. Observed [C ii]158 μm, [O i]63 μm, and FIR continuum flux ratios are reproduced with photodissociation region (PDR) models characterized by moderate far-ultraviolet (FUV) radiation fields with 0.3–1 × 103 and atomic gas densities 3–5 × 103 cm−3, depending on contributions to [C ii]158 μm from ionized gas. We assess the contribution to the [C ii]158 μm flux from an active galactic nucleus (AGN) narrow line region (NLR) using ground-based measurements of the [N ii]122 μm transition, finding that the NLR can contribute at most 20%–30% of the observed [C ii]158 μm flux. The PDR density and far-UV radiation fields inferred from the atomic lines are not consistent with the CO emission, indicating that the molecular gas excitation is not solely provided via UV heating from local star formation (SF), but requires an additional heating source. X-ray heating from the AGN is explored, and we find that X-ray-dominated region (XDR) models, in combination with PDR models, can match the CO cooling without overproducing the observed FS line emission. While this XDR/PDR solution is favored given the evidence for both X-rays and SF in the Cloverleaf, we also investigate alternatives for the warm molecular gas, finding that either mechanical heating via low-velocity shocks or an enhanced cosmic-ray ionization rate may also contribute. Finally, we include upper limits on two other measurements attempted in the Herschel program: [C ii]158 μm in FSC 10214 and [O i]63 μm in APM 08279+5255.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.