Constrained cavity growth models of longitudinal creep deformation of oxide dispersion strengthened alloys

Abstract

Two models of constrained cavity growth are developed to describe the long-term longitudinal creep behavior of nickel based oxide dispersion strengthened (ODS) alloys. For both models the rupture time is taken as the time for a transverse grain boundary to cavitate fully. A diffusive cavity growth law is assumed to govern cavitation. The applicability of the respective models is determined by the particular grain morphology achieved by thermal-mechanical processing. The first model assumes that longitudinal grain boundaries are unable to slide; hence displacements due to cavitation must be matched by displacements due to dislocation creep in adjoining grains. This model predicts a low stress exponent at the transition from single crystal to cavitation creep behavior, and higher stress exponents at stresses below this transition. Good agreement is found between the model predictions and creep data for MA 754 at 1000 and 1093 °C. A second model considers a grain morphology wherein longitudinal grain boundaries are able to slide by means of deformation of pockets of fine grains. Cavitation of transverse grain boundaries is thus controlled by grain boundary sliding. This model predicts a stress exponent of 1 at low stresses, and serves as an upper bound for the creep rate when a duplex grain morphology is present. Model predictions are in good agreement with creep data for a heat of MA 754 with a duplex grain morphology.