Abstract
An understanding of the frictional sliding on faults that can lead to earthquakes requires a knowledge of both constitutive behavior of the sliding surfaces and its mechanical interaction with the loading system. We have determined the constitutive parameters for frictional sliding of initially bare surfaces of Westerly granite, using a recently developed high pressure rotary shear apparatus that allows long distances of sliding and therefore a greater assurance of attaining steady state behavior. From experiments conducted at room temperature and normal stresses of 27–84 MPa several important results have been found. (1) A gouge layer 100 to 200 μm thick was developed from the initially bare rock surfaces after 18 to 70 mm of sliding. (2) The steady state frictional resistance, attained after about 10 mm of sliding, is proportional to the negative of the logarithm of the sliding velocity. (3) Abrupt changes in the velocity of sliding result in initial changes in the frictional resistance, which have the same sign as the velocity change, and are followed by a gradual decay to a new steady state value over a characteristic distance of sliding. This velocity weakening behavior is essentially identical with that found by several previous workers on the same material at lower normal stress. (4) Our results are well described by a two state variable constitutive law. The values of the constitutive parameters are quite similar to those found previously at low normal stress, but the characteristic distance is about an order of magnitude smaller than that found at 10 MPa normal stress with thicker layers of coarser gouge. (5) We have approximated our results with a one state variable constitutive law and compared the results with the predictions of existing nonlinear stability analysis; in addition, we have extended the stability analysis to systems possessing two state variables. With such formulations good agreement is found between the experimentally observed and theoretically predicted transitions between stable and unstable sliding. These results allow a better understanding of the instabilities that lead to earthquakes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have