Consistency of resin composites for posterior use

Abstract

Objectives. The aim of this study was to compare a large set of resin composites suitable for application in stress-bearing areas on the basis of their consistency. Methods. A variety of posterior resin composites were tested using an apparatus that was originally designed for determination of the consistency of elastomeric impression materials (ISO 4823, 1992). The consistency of a standardized volume of resin composite was tested in a dark room at 23°C by loading the samples during 60 s with 1625 g. After loading, the circumference of each sample was determined by a digitizer. Results were analyzed using Tukey-HSD multiple comparisons test and Student's t-tests. Results. The consistency of different brands of composites varied considerably. P50 was the material with the thinnest consistency. Significant differences (p < 0.05) in consistency were found between the same brands of material which were applied directly out of the syringe or out of a preloaded tip. Loading a Centrix tip with one composite out of a syringe resulted in a thinner consistency of the material than when taken directly from the syringe. Significance. A ranking of posterior resin composites is presented to enable a material selection based on consistency.