Abstract

The operating mode of the lighting line depends on the correct choice of conductor cross section. The magnitude of the cross section has an influence on the provision of the required voltage levels on the light sources. The choice of the conductor cross section has been fulfilled based on calculations of the operating mode of the standard line of outdoor lighting specified in the article. Luminaries with high pressure sodium lamps connected through electromagnetic ballasts were used as sources of light. When choosing the conductor cross section of light lines a number of simplifications are commonly used. Attention is paid to the choice of sections without such assumptions: the inductive resistance of conductors is taken into account; the power of the luminaire depends on the voltage level in it. Luminaries with high pressure sodium lamps are the sources of high harmonics. Three variants of calculation are demonstrated depending on the accounting (or non-accounting) of high odd harmonics. The methods of calculating the mode of the lighting line are also presented in the article. The calculation is performed with the aid of Mathcad software. Operating parameters for each phase of the line (i.e. voltage in the items of the scheme, power, currents, power, and voltage losses in all the sections) were determined. The diagrams of the voltage distribution at items of the lighting line for three variants of calculation are plotted for various sections of aluminum conductors. On this basis the choice of the optimum magnitude of the conductor cross section of the lighting line was made. The obtained results of different calculation variants are compared. The comparison of the results obtained with the use of various methods of calculation was made. The impact of high harmonics on the operating mode of the line under consideration has been analyzed. The presence of high harmonics causes an increase of voltage losses, the distortion of sinusoidal voltage. The current of neutral conductor is comparable with the current of phase conductors, besides, the harmonics multiple of 3 are of great importance as they influence on the magnitude of the current.

Highlights

  • Выбор сечений проводников осветительной линии с учетом всех влияющих на него факторов позволяет обеспечивать требуемые уровни напряжения на источниках света во всех режимах, создавая оптимальные условия эксплуатации

  • The operating mode of the lighting line depends on the correct choice of conductor cross section

  • The choice of the conductor cross section has been fulfilled based on calculations of the operating mode of the standard line of outdoor lighting specified in the article

Read more

Summary

Основная часть

Насколько значимым является учет вышеперечисленных упрощений при выборе сечения проводников на примере осветительной линии с односторонним питанием с напряжениями в каждой фазе пункта питания Uф.ном = 230 В. Поэтому участки для каждой из трех фаз и нулевого рабочего проводника одинаковы, независимо от наличия присоединения светильника к рассматриваемой фазе. 1. Расчетная схема линии наружного освещения: UA,, UA,2 – комплексное значение напряжения в первом пункте питания и на первом светильнике фазы. (IА,(1–2), IN,(1–2) – то же полного тока на участке (1−2) фазы А и нулевого рабочего проводника N; Iл,1 – то же полного тока светильника, имеющего первый порядковый номер (обозначения параметров фаз В и С аналогичны). Далее рассмотрены расчеты сечений жилы кабеля вышеуказанной линии наружного освещения без упрощений (1−3). Для всех вариантов расчета принято, что напряжение в пункте питания имеет синусоидальный характер при отсутствии нагрузки (отходящие линии отключены) и действующее значение равно 230 В. Расчеты режимов осуществлены методом последовательных приближений [5]

Учет нелинейности осветительной нагрузки
Расчет режимных параметров
Особенности расчета режима с учетом высших гармоник
Номер высшей гармоники
Значение тока третьей гармоники
Выбор сечения проводника
Упрощенный расчет
Вариант расчета
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call