Abstract

Spectral emissivity control is paramount for designing a high-efficiency selective emitter surface required for thermophotovoltaic (TPV) applications. Owing to the temperature dependency of materials optical constants, the spectral properties of a selective emitter surface changes with the emitter temperature. This paper presents the fabrication of a multilayer metal-dielectric ( S i 3 N 4 / W / S i 3 N 4 ) coated tungsten selective emitter aimed for GaSb-based TPV systems and studies the dependence of its surface spectral emissivity, ε ( λ ) , upon a temperature ranging from 300 K to 1500 K. Both the simulation and experimental methods were used to characterize ε ( λ ) as a function of temperature. For wavelengths less than 1.4 µm, ε ( λ ) was found to have a minimal dependence on temperature. Beyond 1.4 µm, ε ( λ ) increases with the temperature. At 1.55 µm, the simulation and experimental data estimated a ∼ 4 % greater emissivity at 1500 K than at room temperature. At 1500 K, the increased ε ( λ ) at longer wavelengths lowered the spectral conversion efficiency of the selective emitter from 58% to 47%. The output power density, sub-bandgap loss, and TPV conversion efficiency ( η T P V ) for a GaSb cell illuminated by the selective thermal emitter at 1500 K were estimated. η T P V drops from 13.7% to 11% due to the increased sub-bandgap emission at 1500 K. Essential approaches for mitigating the sub-bandgap losses to further improve η T P V are also discussed.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call