Abstract

BackgroundThe complete disassembly of nuclear is the most challenging step in hard cataract surgery through microincision. The classic phaco chop technique often does not succeed, resulting in incomplete nuclear segmentation. The authors describe a technique to improve the efficacy and safety of the initial chopping.MethodsThe consecutive drilling combined with phaco chop technique was devised for very hard cataract through a microincision of 1.8–2.2 mm. 3–4 holes are consecutively drilled into the endonucleus with the phaco tip bevel down, at an angle of approximate 60 degrees and depth of approximately two-thirds of the lens thickness. The initial drilling approaches the capsulorhexis edge and the last drilling approaches the lens geometric center. The nucleus is deeply impaled with the last drilling and firmly engaged with high vacuum, and then chopped with chopper centripetally from the lens equator. The chopper and phaco tip are spread apart laterally after they approach at the center of the nucleus, to create a complete fracture across the entire nucleus. This technique has been adopted in 80 eyes of 65 patients with cataract harder than nuclear opalescence 5 on the Lens Opacities Classification System III scale or mature white cataract with a hard nucleus in the past 12 months.ResultsIn all cases, full thickness segmentation of the hard nuclear including the posterior plate was achieved with this consecutive drilling combined with phaco chop technique. Phacoemulsification and intracapsular implantation of intraocular lens was safely performed in each case. No intraoperative complication such as iris injury, anterior capsule tears, zonulysis or posterior capsule rupture with vitreous loss occurred during surgery. No postoperative complication such as fibrin formation, synechias, severe endothelial cell loss, or endophthalmitis was observed in any case at 6 months postoperatively.ConclusionsThe technique is an efficient, safe, simple, and swift procedure for full-thickness nuclear segmentation, delivering advantage of microincisional phacoemulsifcation for hard cataract with few ocular complications.

Highlights

  • The complete disassembly of nuclear is the most challenging step in hard cataract surgery through microincision

  • We have devised an efficient technique “consecutive drilling combined with phaco chop” for full thickness segmentation of very hard nucleus in coaxial microincisional cataract surgery

  • In all cases, full thickness segmentation of the hard nuclear including the posterior plate was achieved with this consecutive drilling combined with phaco chop technique

Read more

Summary

Introduction

The complete disassembly of nuclear is the most challenging step in hard cataract surgery through microincision. The classic phaco chop technique often does not succeed, resulting in incomplete nuclear segmentation. It has always been a challenge to perform coaxial microincision phacoemulsifcation of cataracts harder than nuclear opalescence 5 on the Lens Opacities Classification System III [1]. Successful surgery through microincision for hard cataract may depend on how well the surgeon divides the lens nucleus into multiple small fragments. The complete segmentation of the dense nuclear into 2 hemispheres becomes the crucial and most challenging step during the whole procedure. Phaco chop has been considered as one of the best techniques for dealing with hard cataracts [3]. Phaco chop technique quite often does not succeed, resulting in incomplete nuclear segmentation and intact posterior plate. Surgeons may attempt to perform the subsequent chop in an unchopped region of the lens by rotating the lens but may exert extra stress to the zonular fiber and lens capsule

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call