Connection between target poisoning and current waveforms in reactive high-power impulse magnetron sputtering of chromium

Abstract

Global models of high-power impulse magnetron sputtering (HiPIMS) plasmas in the literature predict a unique connection between target current waveform and oxidation state of the target (metallic versus poisoned): in the metallic mode, the current waveform reaches a plateau due to metal atom recycling, in the poisoned mode a triangular current waveform is predicted driven by plasma gas recycling. This hypothesis of such a unique connection is tested by measuring the surface chemical composition of chromium magnetron targets directly during reactive high-power impulse magnetron sputtering (r-HiPIMS) by spatially resolved x-ray photoelectron spectroscopy (XPS). The sputtering setup was connected to the ultra-high vacuum XPS spectrometer so that the targets could be transferred between the two chambers without breaking the vacuum. The O2/Ar feed gas ratio, the input power and the pulse frequency of the HiPIMS plasmas were varied. The racetrack oxidation state was measured for different plasma parameters and correlated to the target current waveform shape. It was found that a shift of the target operation from the poisoned mode at low powers to the metallic mode at high powers when operating the discharge at 20 Hz pulse frequency occurs. The transition between these modes was directly correlated with analysis of the Cr2p core level peak on the complete target area. A unique correlation between the metallic and poisoned state of the target and the plateau and triangular current waveform was identified for very low powers and very high powers. In the intermediate power range, such a unique connection is absent. It is argued that the presence of already a small fraction of metal on the target may induce a plateau current waveform despite a significant oxidation of the target. This implies a finite contribution of metal sputtering during the pulse that dominates the recycling and leads to a plateau current waveform. Consequently, the shape of current waveforms cannot easily be connected to target poisoning, but a more detailed modeling of the recycling mechanisms is required.