Conjugate heat transfer simulations of a radially cooled gas turbine blade leading edge using a vortex-based fluidic oscillator for sweeping jet impingement

Abstract

The turbine blades of aero engines are subjected to extremely high temperatures, particularly at the leading edge, where temperatures can reach approximately 1800–2000 K. Therefore, effective heat load management is crucial. A vortex-based fluidic oscillator for sweeping jet impingement was proposed as an innovative cooling method to enhance heat transfer at leading edge of high-pressure gas turbine blades. This numerical investigation evaluates the cooling performance of a vortex-based sweeping jet compared to steady and conventional sweeping jets in a radially cooled high-pressure turbine blade. In this study, a conjugate heat transfer model based on three-dimensional unsteady Reynolds-averaged Navier–Stokes (URANS) equations is employed. The shear stress transport (SST k–ω) model is specifically selected to predict the flow field and heat transfer characteristics of a vortex-based fluidic oscillator applied to the leading edge. To verify the accuracy of numerical calculations, two sets of experimental data were used as benchmark. The results demonstrated strong qualitative and quantitative agreement with experimental data. Various parameters, including coolant mass flow rates (0.171, 0.514, and 0.857 g/s), aspect ratios (0.5, 0.65, and 1), jet-to-wall spacings (H/D = 2, 4, and 6), and pressure drop, were examined to assess overall cooling effectiveness and heat transfer performance. Time-averaged and time-resolved flow field measurements revealed that vortex-based fluidic oscillator significantly enhanced cooling effects and covered a larger impinging area compared to a steady jet. Notably, the vortex-based fluidic oscillator achieved a 24.3% higher heat transfer performance than the steady jet at H/D = 2, with an average temperature decrease in approximately 21 K at leading edge.