Conformable Holographic Photonic Ink Sensors Based on Adhesive Tapes for Strain Measurements.

Abstract

Buildings, bridges, and aircrafts are frequently exposed to fluctuation loads, which could start with a fine crack that instantly leads to unpredictable structure failures. The stationary strain sensors can be utilized, but they are costly and only detect limited deformation forms and sizes. Here, we fabricated photonic strain sensors on adhesive tapes, which can provide real-time monitoring of irregular surfaces. Holographic interference patterning was used to produce nonlinear curved nanostructures of one dimensional (1D) (900 nm × 880 nm) and two dimensional (2D) from a black dye film on a robust uniform adhesive layer and heat resistance tape. The patterned structure of the black dye was stable in broad pH environments. Diffracted light from the curved nanostructure detected the signal during structural damage, a shift or material tear of 5 με at less than 1.3 N cm-2. Additionally, the 2D nanostructure detected a surface change from x or y axis. Tilting the 1D structure within a range of 0.3° to 14.2° provided visible wavelength changes under broadband light to reveal early deflection signs. The curved nanopatterns could be also used for transferable holographic symbol design. Photonic nanopatterns on an adhesive tape could be used as a rapid response, conformable, lightweight, and low-cost dynamic strain sensor.