Confocal Raman Microscopy Enables Label-Free, Quantitative, and Structurally Informative Detection of DNA Hybridization at Porous Silica Surfaces.

Abstract

Characterization of DNA at solid/liquid interfaces remains a challenge because most surface-sensitive techniques are unable to provide quantitative insight into the base content, length, or structure. Surface-enhanced Raman scattering measurements of DNA hybridization on plasmonic-metal substrates have been used to overcome small Raman-scattering cross-sections; however, surface-enhanced Raman spectroscopy measurements are not generally quantitative due to the fall-off in the scattering signal with the decay of the electric field enhancement from the surface, which also limits the length of oligonucleotides that can be investigated. In this work, we introduce an experimental methodology in which confocal Raman microscopy is used to characterize hybridization reactions of ssDNA immobilized at the solid/liquid interface of porous silica particles. By focusing the femtoliter confocal probe volume within a single porous particle, signal enhancement arises from the ∼1500-times greater surface area detected compared to a planar substrate. Because the porous support is a purely dielectric material, the scattering signal is independent of the proximity of the oligonucleotide to the silica surface. With this technique, we characterize a 19-mer capture strand and determine its hybridization efficiency with 9-mer and 16-mer target sequences from the scattering of a structurally insensitive phosphate-stretching mode. Changes in polarizability and frequency of scattering from DNA bases were observed, which are consistent with Watson-Crick base pairing. Quantification of base content from their duplex scattering intensities allows us to discriminate between hybridization of two target strands of equivalent length but with different recognition sequences. A duplex having a single-nucleotide polymorphism could be distinguished from hybridization of a fully complementary strand based on differences in base content and duplex conformation.