Abstract
Modeling and characterization of a magnetic flux compression generator (MFCG) requires detailed knowledge of the changes in conductivity of the MFCG materials during the shock-loading phase. In the studies reported here, a thin metallic strip is shocked with an explosively generated shock wave produced from a charge of composition C-4. The shock wave is intended to simulate the shock wave and pressures produced in MFCG research currently being conducted at Texas Tech University. These pressures are estimated to be between 1 and 3 GPa. The experimental setup is arranged so that the shapes of the metallic strip and shock front are the same, as confirmed using optical fibers. This was to ensure that the test sample was shocked uniformly. The metallic test strip is pulsed with a 70 A current pulse during application of the shock wave. The current and voltage across the test sample are measured directly to determine the change in conductivity. Pressure measurements are conducted in separate tests under similar conditions using strain gauges. The results are then compared to results determined previously using a split Hopkinson pressure bar apparatus (SHPB).
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
