Abstract
ABSTRACTBiologically relevant lipid bilayers supported on highly ordered pyrolytic graphite (HOPG) were probed both mechanically and electrically with a Conductive Atomic Force Microscope (C-AFM) capable of measuring ultra-low currents. Results show that these membranes undergo an elastic response up to 26 nN on average when compressed with an AFM tip. Measuring the films with a low contact force demonstrates that contact mode AFM can be used repeatedly to image without damaging the film. Based on current-voltage measurements made with the C-AFM, it is shown that apparently high resistances seen for the films could be the result of variable electrical contact between the tip and surface. As a result, the paper proposes that the deflection of the cantilever should always be measured in order to ensure knowledge of the location of the tip during all electrical measurements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
