Abstract
Fourier transform infrared (FTIR) spectroscopy, goniometry, and electrical measurements were used to investigate the effect of adding alcohol and carboxylic acid cosolvents to supercritical carbon dioxide (scCO/sub 2/) to condense silanol groups in blanket porous methylsilsesquioxane (p-MSQ) films (JSR LKD 5109). The aliphatic C1-C6 alcohols removed approximately 50% more hydrogen-bonded silanol (SiO-H) groups than pure scCO/sub 2/, leaving isolated silanol groups on the surfaces of the pores. Acetic acid removed H-bonded silanols but left fewer isolated moieties. On a molar basis, n-propanol, isopropanol, and n-butanol removed the largest percentage of silanols per molecule of cosolvent. These cosolvents were also among the lowest vapor pressure cosolvents studied, making them the most environmentally acceptable. As-received ashed ultralow-k MSQ had a contact angle of less than 10/spl deg/ and a dielectric constant of 3.5/spl plusmn/0.1. After processing in a mixture containing 7% n-propanol and scCO/sub 2/, the contact angle was 15/spl deg/ and the dielectric constant decreased to 3.2 /spl plusmn/ 0.1. The surface was hydrophilic after processing in mixtures of cosolvents and scCO/sub 2/ because of the isolated silanol groups on the surface. A comparison of the trends across the alcohol series indicates that cosolvent addition to scCO/sub 2/ increased the solubility of water in the supercritical fluid mixture compared to pure scCO/sub 2/. Within the same class of molecules, the solubility of the cosolvent in the supercritical fluid is a more important selection criterion than the solubility of water in the cosolvent.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.