Abstract

Additive Manufacturing (AM) with the consisting constantly evolving technologies is a particularly popular research area. Based on the shape forming freedom, size, shape, and topology optimization techniques can be validated by AM produced parts. However, in every manufacturing process, AM also has some adverse inherent properties. One and maybe the most significant optimization problem is the mechanical anisotropy caused by the layered structure. In this paper, a simultaneous build orientation and shape optimization method is presented. Both of the approaches are intended to increase the mechanical performance of the produced parts. Shape optimization was accomplished by varying the cross-section of the beam geometries, based on the angle between a PSL section and the characteristic load direction. To test the efficiency and validate the method 2D structures (with relatively small 3rd dimension) and their tensile properties were tested. Based on the results, we can prove that the PSL method works and help to increase the mechanical performance by 19.2% with only 7.8% size increment.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.