Concurrent optimal allocation of geometric and process tolerances based on the present worth of quality loss using evolutionary optimisation techniques

Abstract

Concurrent tolerancing becomes an optimisation problem to find out the optimum allocation of the process tolerances in the given design function constraints. In traditional optimisation methods, finding out the optimum solution for this advanced tolerance design problem is complex. The proposed algorithms (elitist non-dominated sorting genetic algorithm) and differential evolution extensively do better than the previous algorithms for attaining the optimum result. The aim of this paper is to suggest a model for optimal tolerance allocation by considering both tolerance cost and the present worth of quality loss such that the total manufacturing cost/loss is minimised. The suggested model takes into account the time value of money for quality loss and product degradation over time and consists of two new parameters: the planning horizon and the product user’s discount rate. From the outcome of this study, a longer planning horizon results in an increase in both tolerance cost and quality loss; however, a larger value of discount rate gives up a decrease in both tolerance cost and quality loss. Finally, a practical example is brought into reveal the effectiveness of the suggested method.