Conceptual design of a small nuclear reactor for large-diameter NTD-Si using short PWR fuel assemblies

Abstract

A design of a small nuclear reactor for a large-diameter NTD-Si using a conventional Pressurized Water Reactors (PWR) full-length assembly was proposed in previous works. The height of the full-length assembly was 400 cm, and the overall size of the reactor and reflector around the core became large. In addition, the irradiation channel became very long, making handling of the Si ingots in the channel more difficult. The use of a short PWR fuel assembly, with a height of 100 cm, was considered in the current work. With the shorter assembly, the design of the reactor became compact and more practical. Gd2O3 and control rods were used to suppress excess reactivity. Criticality, neutron transport, and core burn-up calculations were performed using the MVP/GMVP II code and MVP-BURN code. Steady-state single-channel thermal hydraulic analyses were also performed. The calculation results showed that the reactor could be critical over 1200 days, and that heat removal from core was possible under 1 atm operating pressure. Large-diameter ingot up to 20 cm in height could be doped with sufficient uniformity. The reactor semiconductor production rate was estimated, and varied between 48 tons/year and 70 tons/year for the 50 Ω cm target resistivity depending on the position of the control rod.