Abstract
A new computer program “PILESET” is developed for use in predicting the bearing capacity and load-settlement behaviour of axially loaded single piles. The program can analyse almost any soil profile and accommodates (a) displacement piles (b) replacement (c) friction piles, (d) end-bearing piles, (e) under-reamed piles and (f) partially sleeved piles. A variety of soil input data can be used, including: (i) standard penetration tests, (ii) cone/piezo-cone tests, (iii) pressure-meter tests and (iv) laboratory tests. The above data types can be combined, if desired, for pile analysis by PILESET. The program calculates the shaft and base capacities of a pile based on 23 methods published in design guides in over 10 European countries. PILESET also predicts the pile load-settlement curve using five published methods, which include two modified load transfer (t-z) approaches formulated by the author. To demonstrate the capabilities of the program, analysis is carried out for case study involving seven full-scale screw piles formed in sand and tested to failure. In each case, the load-settlement curve computed using the author’s modified method in PILESET is found to be in excellent agreement with the actual pile test results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.