Computer simulation of occlusal discrepancies resulting from different mounting techniques

Abstract

The effect of arbitrary mounting of maxillary casts on occlusal relationships was investigated in this study. Maxillary casts of 31 volunteers were mounted on an articulator by use of two split cast bases. This mounting was done first with the arbitrary face bow and second with a hinge bow. Three reference points were defined and measured on each maxillary cast with a three-dimensional digitizer. The measurements were taken from the arbitrarily mounted cast and from the cast mounted according to the hinge axis. Opening and closing movements that were transferred according to the hinge axis. Opening and closing movements that were transferred from the articulator to the mouth of the patient were simulated by a computer based on measurements of the reference points. The results revealed that the use of an arbitrary face bow causes a deviation of the hinge-axis points from the precise axis of more than 5 mm in 77% of the cases. Resulting occlusal errors depended on the angles between the arbitrary and precise axes and the direction of the axis shifts. The occlusal error is roughly proportional to the shift or tilting of the hinge axis in millimeters or degrees. For a given deviation of the arbitrary and precise axes, the occlusal error is proportional to the record height. For a record height of 2 mm or more, an occlusal error of more than 0.1 mm will occur. An average occlusal error of more than 0.1 mm would most likely lead to the necessity of extensive selective grinding of occlusal discrepancies in the patient's mouth.