Computer Modeling Analysis of the Talar Dome as a Graft for the Humeral Head

Abstract

To study the degree of surface congruency between the talar dome and humeral head, to determine the size of graft harvestable from the talar dome, and to determine if there are surrogate markers that correspond to a higher degree of surface congruency. Computer models of 7 nonmatched humeral heads and 7 talar domes were generated by digital segmentation of magnetic resonance (MR) images. Modeled defect regions of each humeral head were then aligned with medial and lateral surfaces of each talar dome using software to maximally limit surface mismatch. Modeled defect sizes ranging from 24× 10mm to 30× 10mm were tested. Congruence match of <1mm separation was then measured. The average surface match between randomly selected talar domes to humeral head surfaces was 87.2% when 1mm was selected as the maximal acceptable congruence difference. Congruence match was not affected by graft size or laterality of talar dome as source of graft. Matching radius of curvature of talar dome to humeral head and height of donor to recipient correlated with improved congruence match. Under best match conditions, a maximal congruence match of 95.2% was achieved. The present study indicates that the talar dome can be a potential source of osteochondral allograft for Hill-Sachs lesions with a maximal defect size of 30× 10mm for a single graft. Larger graft sizes resulted in decreased success of actual graft harvest as a result of dimensional constraints of the talar dome. Additional studies are required to determine the biomechanical compatibility of this graft. The talar dome has a high degree of surface congruency in comparison with the humeral head though the maximal graft size harvestable limits its clinical applicability.