Computer assisted neurosurgical planning and guidance system in China

Abstract

In this paper a method for TCAD evaluation of RF-power transistors in high-efficiency operation using harmonic loading is presented. The method is based on large signal time-domain computational load-pull. Active loads are used in the harmonic load-pull for simulation time reduction. With the method device performance under different harmonic load impedance can be investigated at an early stage in the design process. Alternative designs can be compared and the mechanisms affecting device efficiency in class-F can be studied at chip-level. For method validation, a case study is made on an LDMOS transistor. The transistor is load-pulled in class-AB and then optimized for efficiency at 2f0 and 3f0 using a novel approach with passive fundamental load and active harmonic loads. A swept simulation is conducted using passive fundamental and harmonic loads. Waveforms in compression are analyzed and the mechanisms creating the increased efficiency in class-F are identified by a comparative study to class-AB. Class-F harmonic termination is shown to give a 17% overall reduction of dissipated power and a 9% increase in output power. The expected efficiency increase is about 3–10% in the compression region depending on level of compression.