Abstract
Computed tomography (CT) is the only dimensional measurement technology that captures holistic geometric information of the complete object. The availability of equally and densely distributed measurement data gathered by CT enables the consideration of local form deviations of the object's surface for the definition of a datum system. A datum system describes a coordinate system that is used for referencing geometrical tolerances. Therefore, the datum definition by an approximation of datum features is replaced by a fitting method called virtual assembly (VA), where the datum surfaces are registered in order to simulate the real, physical workpiece contact. Besides describing the theory, in this paper the method is evaluated using a linear guide assembly as an example that is compared to the real assembly of the object.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
