Abstract
Existing research on PTFE-based reactive materials (RMs) mostly focuses on Al/PTFE RMs. To explore further possibilities of formulation, the reactive metal components in the RMs can be replaced. In this paper, Zr/PTFE and Ti/PTFE RMs were prepared by cold isostatic pressing and vacuum sintering. The static and dynamic compressive mechanical properties of Zr/PTFE and Ti/PTFE RMs were investigated at different strain rates. The results show that the introduction of zirconium powder and titanium powder can increase the strength of the material under dynamic loading. Meanwhile, a modified J-C model considering strain and strain rate coupling was proposed. The parameters of the modified J-C model of Zr/PTFE and Ti/PTFE RMs were determined, which can describe and predict plastic flow stress. To characterize the impact-induced reaction behavior of Zr/PTFE and Ti/PTFE RMs, a quasi-sealed test chamber was used to measure the over-pressure induced by the exothermic reaction. The energy release characteristics of both materials were more intense under the higher impact.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
