Compressive behavior of SLA Open-Cell lattices: A comparison between Triply Periodic Minimal Surface Gyroid and Stochastic structures for artificial bone

Abstract

This study evaluates the compressive properties of stereolithography (SLA) fabricated open-cell lattices, specifically triply periodic minimal surface (TPMS) gyroid and stochastic structures, for artificial bone applications. Two resins, Standard White and BioMed Amber, were tested across four relative densities (0.2, 0.3, 0.4, 0.5). Mechanical characterization of horse tuber coxae trabecular bone used as a biological comparator showed an average elastic modulus of 0.05 GPa and a yield strength of 3.369 MPa. Gyroid structures exhibited higher elastic modulus and yield strengths, with BioMed Amber gyroid at a density of 0.5, achieving an elastic modulus of 0.623 GPa and yield strength of 14.149 MPa. Stochastic structures showed lower and more variable mechanical properties. The highest yield strength for stochastic structures was observed in BioMed Amber at a density of 0.5 (14.199 MPa). Comparative analysis indicated that high-performing synthetic structures approach the lower bounds of natural bone properties. Using a field-driven design approach, variable relative density structures were developed to emulate the mechanical properties of natural bone. SEM analysis provided insights into failure mechanisms, highlighting the impact of relative density on structural integrity and material ductility. This research supports the development of 3D-printed bone-like structures as viable substitutes for cadaveric specimens in preclinical tests, with implications for material science and orthopedic applications.