Compressional wave velocity and attenuation at ultrasonic and sonic frequencies in near‐surface sedimentary rocks

Abstract

Laboratory ultrasonic measurements of compressional wave velocity and attenuation were made as a function of effective pressure on samples of limestone, sandstone and siltstone taken from a shallow borehole test site. The results indicate that the sandstones are pervaded by grain contact microcracks which dramatically affect their compressional wave attenuations. Clean sandstone shows a compressional wave quality factor (Q{sub p}) of 24 {+-} 2 at 5 MPa effective pressure (close to the estimated in situ burial pressure) and a Q{sub p} of 83 {+-} 29 at 60 MPa. The Q{sub p} of limestones and siltstones at the site show negligible and small increases with pressure in the laboratory, respectively. The strong pressure dependence of Q{sub p} in clean sandstone was used to infer the presence of in situ microcracks. Sediment velocities measured in the laboratory at about 1 MHz were compared with those from the full waveform sonic log at about 10 kHz implies that they must also be highly attenuating over a significant part of the frequency range 10 kHz to 1 MHz, to account for the magnitude of the observed velocity dispersion. Assuming the laboratory Q{sub p} values measured at 5 MPa remain constant down to 10 kHzmore » predicts the observed dispersion quite well. Furthermore, the sonic log velocities of sandstones, limestones and siltstones (after normalizing each lithology for porosity and clay content) were found to reflect the same pressure (depth) trends observed in the laboratory. The results provide evidence for the existence of in situ microcracks in near-surface sediments.« less