Compression test of a single carbon fiber in a scanning electron microscope and its evaluation via finite element analysis

Abstract

A longitudinal compression test for a single polyacrylonitrile-based carbon fiber (T300) was performed using a scanning electron microscope. The compressive stress/strain behavior was initially linear, but subsequently became nonlinear. The longitudinal tangent modulus decreased with increasing compressive strain. A cyclic compression test revealed that the T300 carbon fiber deformed elastically up to ~90% compressive strength. The variability in the compressive strength was evaluated using Weibull analysis. The representative compressive strength of the T300 carbon fiber was nearly the same as the tensile strength. The compressive strength of the T300 carbon fiber was almost same as that of the high-tensile strength T800S carbon fiber. Finite element analysis was performed to investigate the validity of the test method. The results showed that the longitudinal compressive stress on the carbon fiber varied during longitudinal compressive loading. The maximum longitudinal compressive stress in the carbon fiber was slightly higher than the average compressive strength applied at the end. However, the variability in the measured compressive strength was much higher than that in the longitudinal compressive stress on the carbon fiber, which does not affect the former.