Compression properties of glued laminated timber and tensile properties of gluelam lamellas from oil palm wood

Abstract

ABSTRACT When oil palm lumber is considered for load-bearing products such as glued laminated timber (GLT), defined strength and stiffness values are required. In this investigation, combined GLT from oil palm wood is tested in compression parallel and perpendicular and glulam lamellas in tension parallel to the vascular bundles. Strength and Young´s modulus in compression and tension parallel increase with the density by power law relationship. In contrast to dicotyle­dons, the strength in construction size exceeds that of small, defect-free test specimens (compression strength perpendicular), are in the same range (tensile and bending strength parallel) or only a little below (compression strength parallel). The specimen size does not influence the strength. The ratio of fc,0 : fm : ft,0 is 1.2 : 0.8 … 1.7 … 2.6 : 1 and fc,0 : fc,90 = 2.7 … 13.0 … 32.6 : 1 for ρ = 200 … 400 … 600 kg/m³; the ratio of Ec,0 : Em : Et,0 is 1.2 : 1.3 : 1 for ρ = 400 kg/m³. Ashby´s performance indices for minimum weight design rise with the density; the strength-density performance indices are comparable or only slightly lower than that for structural size softwood, whereas the modulus-density performance indices are much lower. The challenge in use of oil palm wood for load-bearing construction products is the low stiffness.