Abstract

BackgroundEngineered stone silicosis is an emerging disease in many countries worldwide produced by the inhalation of respirable dust of engineered stone. This silicosis has a high incidence among young workers, with a short latency period and greater aggressiveness than silicosis caused by natural materials. Although the silica content is very high and this is the key factor, it has been postulated that other constituents in engineered stones can influence the aggressiveness of the disease. Different samples of engineered stone countertops (fabricated by workers during the years prior to their diagnoses), as well as seven lung samples from exposed patients, were analyzed by multiple techniques.ResultsThe different countertops were composed of SiO2 in percentages between 87.9 and 99.6%, with variable relationships of quartz and cristobalite depending on the sample. The most abundant metals were Al, Na, Fe, Ca and Ti. The most frequent volatile organic compounds were styrene, toluene and m-xylene, and among the polycyclic aromatic hydrocarbons, phenanthrene and naphthalene were detected in all samples. Patients were all males, between 26 and 46 years-old (average age: 36) at the moment of the diagnosis. They were exposed to the engineered stone an average time of 14 years. At diagnosis, only one patient had progressive massive fibrosis. After a follow-up period of 8 ± 3 years, four patients presented progressive massive fibrosis. Samples obtained from lung biopsies most frequently showed well or ill-defined nodules, composed of histiocytic cells and fibroblasts without central hyalinization. All tissue samples showed high proportion of Si and Al at the center of the nodules, becoming sparser at the periphery. Al to Si content ratios turned out to be higher than 1 in two of the studied cases. Correlation between Si and Al was very high (r = 0.93).ConclusionSome of the volatile organic compounds, polycyclic aromatic hydrocarbons and metals detected in the studied countertop samples have been described as causative of lung inflammation and respiratory disease. Among inorganic constituents, aluminum has been a relevant component within the silicotic nodule, reaching atomic concentrations even higher than silicon in some cases. Such concentrations, both for silicon and aluminum showed a decreasing tendency from the center of the nodule towards its frontier.

Highlights

  • Silicosis is an occupational respiratory disease produced by the inhalation of respirable crystalline silica; after disease onset, pulmonary fibrosis occurs, which can lead to respiratory failure and death [1]

  • Considering the mostly present elements in the X-ray fluorescence (XRF) studies, O and Si were measured in percentages that agree well with the 2:1 ratio corresponding to ­SiO2

  • Since XR fluorescence focus in a much smaller region of the sample than XR diffraction, probably a similar tectosilicate of the feldspar mineral group consisting in a solid solution of albite and anorthite endmembers ­(NaAlSi3O8–CaAl2Si2O) was probed in the portion of the sample M7 tested by XRF, considering the elemental quantifications

Read more

Summary

Introduction

Silicosis is an occupational respiratory disease produced by the inhalation of respirable crystalline silica; after disease onset, pulmonary fibrosis occurs, which can lead to respiratory failure and death [1]. In the 1990s, the commercialization of a compound artificial material called quartz agglomerate, artificial stone or engineered stone (ES) began This material is manufactured with finely crushed rock, with a silica content generally greater than 90%, together with pigments and polymeric resins [3] acting as binders of the inorganic portion. Engineered stone silicosis is an emerging disease in many countries worldwide produced by the inha‐ lation of respirable dust of engineered stone This silicosis has a high incidence among young workers, with a short latency period and greater aggressiveness than silicosis caused by natural materials. Different samples of engineered stone countertops (fabricated by workers during the years prior to their diagnoses), as well as seven lung samples from exposed patients, were analyzed by multiple techniques

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call