Complex transcatheter left atrial appendage closure using a tailored trans-jugular approach simulated by 3D printing: a case report.

Abstract

BackgroundTranscatheter left atrial appendage (LAA) closure (LAAc) is less feasible in patients with unusual LAA anatomy.Case summaryA 65-year-old woman with persistent atrial fibrillation was referred for LAAc. Transesophageal echocardiography (TEE) revealed spontaneous contrast in the LAA without formation of a thrombus; the LAA shape was tortuous and difficult to assess. A first LAAc procedure was unsuccessful given the unsuitable sheath position. Therefore, a soft three-dimensional (3D) model printing was performed by laser sintering and revealed excessive sheath kinking with an inferior approach, but successful deployment would be feasible using a superior approach. Successful trans-jugular implantation of a Watchman FLX 31 device in stable position without residual leakage was achieved during the subsequent procedure. At 3-month follow-up, and after cessation of oral anticoagulation, the patient’s symptoms improved. Imaging demonstrated complete LAA occlusion and correct placement of the device along the LAA superior axis.DiscussionThis is the first-reported clinical case of a complex transcatheter LAAc through a trans-jugular approach. Simulating the patient’s anatomy with a laser sintering 3D-printed model showed why the transfemoral approach failed, validated the trans-jugular procedure, enabled selection of the simple curve access sheath that had the most direct trajectory towards the LAA, confirmed that transseptal puncture was possible, allowed determination of the angle of puncture, enabled selection of the most appropriate LAA device and had a very low cost compared with planning software or other printing methods.