Abstract
Relationships between the parameters of a bipolar-transistor (BT) common-base power amplifier, which provide compensation of the flicker component of the phase noise of the output signal during operation in the linear mode, are obtained. This effect is revealed in the microwave frequency band by means of numerical simulation. It is shown that after introduction of nonlinear parameters in the BT equivalent circuit, the effect persists in some vicinity of the compensation point calculated for the linear case.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Communications Technology and Electronics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.