Abstract
An alternative to the commonly used technique of mitring for compensation of microstrip bends is described. Experimental data are presented for the case where a square cutout is removed, at either the inner or outer corner of the 90° bend. This approach eases artwork generation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
