Abstract
The output of a force sensor can change over time under constant load as a result of anelastic creep of components. An empirical model of this behavior in force sensors is presented. Unlike previous work, the model does not a priori assume an exponential functional form for the creep. Once parameters are obtained in a simple calibration procedure, sensor output can be quantitatively predicted, and the error that would otherwise appear in the measurement can be corrected mathematically. The proposed model captures over 98% of anelastic behavior in the bending beam load cell studied and is expected to apply to other force sensors as well, including wind-tunnel strain-gauge balances. The model also helps visualize the consequences of anelastic creep in typical calibration and test scenarios. Results demonstrate that creep-induced error can reach or even exceed 0.3% of measured load, depending on the quality of the sensor and the load schedule. Examples are given of loading patterns susceptible to the error.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.